Behavior of dry sliding corrosion property of boron carbide-reinforced aluminum-magnesium alloy
DOI:
https://doi.org/10.54172/mjsc.v27i1.261Keywords:
خاصية التآكل , سبيكة الألومنيوم - ماغنيسيوم , المقواة بحبيبات كربيد البورونAbstract
This paper studies the mechanical wear behavior of a composite based on an aluminum-magnesium alloy reinforced with boron carbide grains. A mechanical wear tester was used to estimate the wear process of the composite under different loads and sliding speeds against a rotating cylinder of high hardness steel, which is estimated at 500 HV. It was found that the mechanical corrosion resistance of the composite is much greater than that of the aluminum-magnesium alloy, and the composite also showed a much higher value of the corrosion resistance to failure than the base alloy. The surfaces of the samples that fell under the influence of friction were studied by optical microscope.
References
Jiang, J.Q., Tan, R.S., Ma, A.B., Mater Sci. Technol., (1996), 12,p. 483.
Sannino, P., Rack, H.J., Wear , (1996) , 197,p. 151.
Rohatgi, P.K., Cast Metal Matrix Composite, Metal Hand Book, Casting, 9th ed. vol. 8, ASM Publications, (1988), p. 840.
Rigney, D.A., Fu, X.Y., Hammerberg, J.E., Holian, B.L., Falk, M.L., Scripta Mater. (2003) 49, p. 977.
Downloads
Published
Issue
Section
License
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
Copyright of the articles Published by Almukhtar Journal of Science (MJSc) is retained by the author(s), who grant MJSc a license to publish the article. Authors also grant any third party the right to use the article freely as long as its integrity is maintained and its original authors and cite MJSc as the original publisher. Also, they accept the article remains published by the MJSc website (except in the occasion of a retraction of the article).
